CC2650: cc2650

DHIREN SAHOO

Prodigy 160 points

Part Number: CC2650

how to generate pn generator modulated signal in CC2650 using smart rf studio V7.

please inform the setting for expert mode for BLE phy pn9 signal testing.

over 6 years ago

0 Simon J over 6 years ago

TI__Genius 11810 points

Hi,

If you tick of the whitening checkbox default BLE whitening will be used.

-Simon

0 DHIREN SAHOO over 6 years ago in reply to Simon J

Prodigy 160 points

Thanks Simon for yur support

I want to know the configuartion of default setting conatins for BLE PN9 signal in smart rf studio v7 for Cc2650

Dhiren

0 Simon J over 6 years ago in reply to DHIREN SAHOO

TI__Genius 11810 points

Hi,

Do you want to do BLE PHY testing using PRBS9 packet payload? This is not supported in SmartRF Studio, but you can use the Host Test example from the SDK together with BTool.

-Simon

0 DHIREN SAHOO over 6 years ago in reply to Simon J

Prodigy 160 points

Hi Simon ,

please sendme the link from where i can get the host test example for BLE phy testing for PN9 .

Dhiren

0 Simon J over 6 years ago in reply to DHIREN SAHOO

TI__Genius 11810 points

Hi Dhiren,

Download the BLE SDK: www.ti.com/.../BLE-STACK When installed you'll find the host test example inside. Flash that example on you board and use BTool to send HCI commands to your board.

HCI functions are documented here: dev.ti.com/.../group___h_c_i.html

You can use HCI_EXT_EnhancedModemHopTestTxCmd with payloadType LL_DIRECT_TEST_PAYLOAD_PRBS9.

-Simon

Bluetooth®︎

Bluetooth forum

CC2650: cc2650