cc2500 - transmit mode

talmor zilberman

Other Parts Discussed in Thread: CC2500

Folks,

I'm working with evm5515 and cc2500 transceiver.

I was able to read and write into the cc2500 registers

but when I'm trying to transmit data (by writing into TX FIFO register and sending the STX strobe), the transceiver gets stuck in TX mode and nothing is sending out.

Any help is appreciated.

Talmor

over 14 years ago

0 BrandonAzbell over 14 years ago

TI__Guru 64580 points

So have you now resolved the issue of your other post?

http://e2e.ti.com/support/dsp/tms320c5000_power-efficient_dsps/f/109/t/100917.aspx

If so, please post your results to let others know the resolution to the issue.

I am moving this to the Low Power RF forum associated with the hardware. I would suggest not using the /etc - RF forum.

0 talmor zilberman over 14 years ago in reply to BrandonAzbell

Expert 1160 points

no,

there is no way to toggle the CS pin .

0 Jim Noxon over 14 years ago in reply to talmor zilberman

TI__Genius 14940 points

I think I'm missing something. It almost sounds like you have an understanding of the problem and are asking if there is an alternative work around due to the configuration of your setup. Can you catch me up as to exactly what the history is and what your understanding of how the CS line may be interfering with your operation?

Jim Noxon

Other wireless

Other wireless technologies forum

cc2500 - transmit mode