TMS3705

Hi Ales,

Please take a look at the attached application note which describes the downlink and uplink bytes.

Also, the attached technical training should be useful.  This shows the string the GUI sends or receives along with the TXCT and SCIO relationship. 

Thank You, Eddie, very much.

Best Regards,

Ales

Thank You again. But, I stil have one Questions. 

Namely, I"m little confused. When we locking Palfi *general read of Page 3*,  I becom so far End of Burst phase, then I write  0C_h  (so far, everithing is O.K., because I make my own Reader with Atmega and compare SCIO line with SCIO line on TI Reader)  When I wrote  0C_h, TXCT=high and SCIO also.  After about 2ms, SCIO goes down. O.K.

But, what now? In dokumentation, I see, the Answer from Palfi is on SCIO line. Or not? And what is on TXCT line? I see, some strange higher Frequency.

In Fact, what kind of Procedure must I make, to get correct Answer from Palfi ? Must I looking falling or raising Edge on SCIO, maybe must i generate 10 x 8 clock on TXCT ?

I traying everithig already 7 Days, and I"m already desperate.

Can You help me, please?

Best egards, Ales