CC2530 IMPEDENCE MATCHING

Soumya Subramanya

Other Parts Discussed in Thread: CC2530

Is there a reference design for the impedence matching section(for CC2530), for a 50ohm UFL connector instead of an SMA connector?

0 RGW over 13 years ago

Just change the footprint of the SMA connector to the UFL connector footprint. No other changes should be necessary since both are matched to 50ohms.

Regards, Richard

0 Soumya Subramanya over 13 years ago in reply to RGW

Thank you!...:)

Other wireless technologies forum