Designing RFid reader

Shoban - 

this third party is making UHF EPCGen2 interrogators with CCxx devices. 

http://tsscompany.eu/ 

You can interface with them and if you are planning on making indoor tracking system you may need to discuss with them using their EVM + amplifier and/or antenna with enough gain, so you can get enough ERP/EIRP to provide coverage you are looking for. 

http://tsscompany.eu/murm-evaluation-board/ 

Thank you for our valuable reply ,

But I would be grateful to you if could provide me solution to implement the indoor tracking system using TI EVM's and IC's only.

Sorry - 

we don't have anything like that available. 

Ohh Okay thank You Sir,

Just asked as I had to fill three of ti components for analog design contest,if it isnt possible fine , thank u sir

if you are participating in that contest - then its a little different situation - I'll forward this post to the correct apps guy in LPRF. 

Thank U ,Once again Sir.

Shoban - 

I have emailed the guy twice now with the link to this post - I will call him tomorrow as well. Maybe he is on vacation or was busy with other tasks. 

Ohk  Thank U sir, I do need them,Could U give the design and does the design support multiple antennae ports and will the reader sense non TI UHF Tags?

OK, attached are the block diagrams. No, it has only one antenna.

May I know your Company name, application and the requirement.

Thanks,

PM 

5187.TI_RFID Reader_June 25.pdf

Thank U sir,

My Name is Shoban, I am a student of SSN College of Engineering in Chennai in India.I am Participating in TI Analog design Contest for which We are planning to do a Indoor TRACKING OF OBJECTS USING a SINGLE RFID TAG.So this would Either require more readers or multple antennae to give the location.

We require a range of atleast 5 meters non line of sight reach and a decent signal strength from antennas to deduce the location using Direction of arrival.