Silabs IDE for CC25xx

Igor Dranov

Other Parts Discussed in Thread: CC2511

Hi,
Is it possible to program and debug Texas Instruments MCU СС2511 (www.ti.com/.../cc2511;tisearch=Search-EN) using Silicon Labs IDE (www.silabs.com/.../8-bit-microcontroller-software.aspx) and one of this two adapters
*Silicon Labs: "USB Debug Adapter" www.silabs.com/.../USBDebug.aspx
*Texas Instruments: "Debugger and Programmer" www.ti.com/.../cc-debugger
If that is possible, could you give me advice what and where should I change in Options/Properties of Silicon Labs IDE?
Thank you.
Igor.

over 10 years ago

0 TER over 10 years ago

TI__Guru**** 317180 points

No, different pinout on the header.

0 Igor Dranov over 10 years ago in reply to TER

Prodigy 170 points

Sorry, but I don't understand what do you mean?

By default, Silabs IDE has not any header for CC25xx. So anyway it's needed add someone header to IDE paths or into the project. Question is Which exactly header I should add, and what else I should add to project and what I should change in Project Properties(and maybe something else). Can I use header for CC2511 from IAR IDE?(ioCC2511.h)

Other wireless

Other wireless technologies forum

Silabs IDE for CC25xx