CC2530EMK - programming flash without the Development Kit

Vinayak kumar

Other Parts Discussed in Thread: CC2530, CC2530EMK, CC2530EM

Hello Guys,

I have CC2530EMK (Evaluation Kit) for CC2530. Now I would like to program the CC2530 without using any development kit. Is it possible? And if yes, how I can do that.

Thanks,

Vinayak

over 15 years ago

0 x893 over 15 years ago

Prodigy 105 points

I use simple microprocessor atmega168 (arduino compatible handmade pcb with 2 resistors, caps and USB-serial adapter)
Of couse you can any MCU and make soft for flash file via CC protocol.
After i make CC debugger pcb and flash file from TI flash programmer.
But it's only for use debug mode.
http://akb77.com/g/rf/program-cc-debugger-cc2511-with-arduino/

0 Vinayak kumar over 15 years ago in reply to x893

Prodigy 55 points

Hello x893,

Thanks for the reply.

do you have any documentation for the CC Protocol? I have a small development borad for MSP430 and would like to use that one to program this CC2530EM board.

0 x893 over 15 years ago in reply to Vinayak kumar

Prodigy 105 points

http://focus.ti.com/general/docs/litabsmultiplefilelist.tsp?literatureNumber=swra124

Other wireless

Other wireless technologies forum

CC2530EMK - programming flash without the Development Kit