Dev pack debugger

The default project use XDS100v3 as debugger. You have to change it to XDS110 USB probe by yourself.

Ya,  we have already made those settings and build the project but still its giving same error...

but while installing ti_emupack both version i.e.

6.0.14.0 and 6.0.14.5 we are unable to install it completely

the errors are listed below

1)Driver Certification failed 

2)XDS100 installation failed.

as well xds110 installation failed

Try to download and install Flash Programmer 2. Then, start Flash Programmer 2 with XDS110 plug into your PC and Flash Programmer 2 will do FW update to your XDS110. After FW update, start CCS again to see if it works.

We updated XDS110 Deva Pack Debugger and connected back to ccs and tried debigging the program but still its giving error 242 router subpath could not be accessed..

If you use Flash Programmer 2 and your XDS110 to download prebuilt hex file to your CC2640, does it work?

Where do i find Prebuilt hex file?

You can find them under BLE installation folder\ accessories\HexFiles

Thanks chen.

Even though i connected my hardware thru Dev Pack Debugger.

You can see our hw and Dev pack debugger connection

And we have connected browsed and added .hex file but not able to download it and test, Why its showing unknown Device,?

It seems that the connection between XDS110 and your CC2640 is not good or correct. I suggest you to check if your CC2640 is well powered.