PER tester

Patrice Galleau

Other Parts Discussed in Thread: CC2530

Hello,

I am trying to use the CC2530DK to test PER tester. The quick start guide refers to some menus on the LCD (PER Tester). On my LCD it is writtent Light Switch instead. Is it a firmware prob ? Have you ever had this problem ?

thanks a lot.

Patrice

over 15 years ago

0 Bjørn over 15 years ago

TI__Expert 4470 points

Hi Patrice,

The light_switch example is another application and not the same as PER tester (its distributed in the same source package as the PER tester though). Source code and hex files for these examples are found in this zip file:

http://www.ti.com/litv/zip/swrc135b

You will need to reprogram the board with the PER tester firmware. You can do this either from TI SmartRf Flash Programmer or from IAR EW. Both alternatives are described in the document "CC2530_Software_Examples.pdf" that is found in the same zip file.

regards,

Bjørn

0 Patrice Galleau over 15 years ago in reply to Bjørn

Prodigy 20 points

Hello,

Thank a lot. I am going to install the right soft.

Other wireless

Other wireless technologies forum

PER tester