CC1200: How can I set RF power for transmission

Harshal Joshi

Part Number: CC1200

Hi,

I am using K32L2B31 NXP MCU along with CC1200 RF Transreceiver for one of the project. We are using Synchronous serial mode of RF module.

I am unable to figure out how can I set RF power for transmission. Can anyone guide on how it can be done?

0 TER over 4 years ago

Please refer to the "PA Output Power Programming" chapter in the UserGuide

0 Harshal Joshi over 4 years ago in reply to TER

I could not understand exactly which register values can be updated.

I want to update 15 dBm power in CC1200.

can anyone give example on to set above power.

0 TER over 4 years ago in reply to Harshal Joshi

Have you set the wanted output power in SmartRF Studio and read out the register value that is needed?

0 Harshal Joshi over 4 years ago in reply to TER

Currently I do not have MSP430 eval board available with me and not sure if I can use Smart RF without that.

+1 TER over 4 years ago in reply to Harshal Joshi

You can use SmartRF Studio to find settings without any board connected.

Sub-1 GHz forum