• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 54 subscribers
  • Views 178 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

CC1352P: The program fleets on startup

Katherine Wang
Intellectual 2210 points
Part Number: CC1352P

Hi Team,

I am debugging cc1352 (official beta version) as shown in the picture.

With TI15.4 protocol stack, I feel that it was due to the configuration that a system error occurred.

The configuration is as follows.

Could you please help me see find out the cause?

Kind regards,
Katherine
  • 0
    TI__Mastermind 20407 points

    Hi Katherine, 

    It is possible that your HW set up could be the issue. I see that you are powering the device with external power but the power selection jumper on the launchpad next to BTN-2 is in the XDS-powered mode. This could be the issue. 

    Also, if the above jumper selection doesn't solve the issue, please try to debug the empty project from the SDK. This should eliminate or point to SW issue rather than debug setup issue. 

    Regards,
    Sid