CC113L: Request a set of configuration parameters

Chaoyu Huang

Part Number: CC113L
Other Parts Discussed in Thread: CC110L

Tool/software:

Hello

My requirement: Based on the provided radio frequency parameters, request a screenshot of the configuration parameters on the Smartrf studio software and the exported parameters.

The signal parameters of the transmitter are as follows:

The data frame format is as follows:

The manchester as follows:

Best regards,

HuangChaoyu

4 months ago

0 ZC 4 months ago

TI__Genius 17955 points

Hi HuangChaoyu,

Typically customers develop their specific PHY settings themselves if not using one of the characterised default PHYs in SmartRF Studio 7 - we can then help with specific questions on this forum. If it is a large opportunity, please contact your assigned FAE regarding this for more direct support.

You can start with one of the 868 MHz default PHYs and change the frequency to 433.92 MHz, adjusting the other parameters from there. Please see: https://e2e.ti.com/support/wireless-connectivity/sub-1-ghz-group/sub-1-ghz/f/sub-1-ghz-forum/446188/cc1101-433-mhz-smartrf-settings

The CC110L Datasheet: https://www.ti.com/lit/swrs109 provides a lot of information about configuring the relevant registers, but for most of the parameters it is recommended to use SmartRF Studio 7 to configure them.

Regards,

Zack

Sub-1 GHz

Sub-1 GHz forum

CC113L: Request a set of configuration parameters