CC1314R10: Even when setting the transmission power of the board to MAX (14dBm), it only outputs 8dBm.

K.Z

Part Number: CC1314R10

Tool/software:

Hi All,

I was supported by ZC-san on this E2E, but I have lost contact with him.
I can't contact him via private message either.

CC1314R10: Even when setting the transmission power of the board to MAX (14dBm), it only outputs 8dBm. - Sub-1 GHz forum - Sub-1 GHz - TI E2E support forums

Can someone please support me instead?
I will send you a file to your private message, please check the parameters.

Best Regards,

Ito

4 months ago

0 Theo Lange 4 months ago

TI__Expert 7645 points

Hi K.Z.,

I apologize for the delay in support.

Could you please share with me the ti_radio_config.c and ti_radio_config.h file that is generated for your project (in the generated sources folder)?

Kind regards,
Theo

+1 K.Z 4 months ago in reply to Theo Lange

Expert 2490 points

Hi Theo.

Thank you for your help.

I have sent you a private message.
Friend request sent to you.

Best Regards,

Ito

0 K.Z 3 months ago in reply to Theo Lange

Expert 2490 points

Hi Theo,

Thank you for your help.

How is your progress.

Best Regards,

Ito

0 K.Z 3 months ago in reply to Theo Lange

Expert 2490 points

Hi Theo,

Can you give me a reply?

Best Regards,

Ito

0 Theo Lange 3 months ago in reply to K.Z

TI__Expert 7645 points

Hi Ito,

please see my reply in our private chat.

I will send you another update as soon as I have feedback from the design check.

Kind regards,
Theo

0 K.Z 3 months ago in reply to Theo Lange

Expert 2490 points

Hi Theo,

Thank you for your help.

How is your progress.

I have also included my response to ZC in a private message.

Best Regards,

Ito

0 K.Z 3 months ago in reply to Theo Lange

Expert 2490 points

Hi Theo,

Can you give me a reply?

Best Regards,

Ito

0 K.Z 3 months ago in reply to Theo Lange

Expert 2490 points

Hi Theo,

Can you give me a reply?

This issue has not been resolved for several months.

Best Regards,

Ito