CC1310: Firmware upgrade methods?

Blake Carpenter

Part Number: CC1310
Other Parts Discussed in Thread: WMBUS

Tool/software:

My assigned focus customer asks:

We are using CC1310 to implement W-MBus T1 mode with the stackforce stack that you provided to us. Is there a way to perform a FW upgrade of the module? If not... is there a pin to pin compatible device that could allow it?

Any advice?

Best Regards, Blake

11 months ago

+1 Marie H 11 months ago

TI__Guru* 83901 points

Hi Blake,

Is this over the air firmware upgrade they mean?

The Stack Force WMBUS stack doesn't support OAD. In most cases, the CC1310 will be connected to a host device, and I think this is supposed to be the vector for FW upgrade. (The data rate of WMBUS is very low.)

If you have the new FW image on a host device, I would recommend using the ROM bootloader to upgrade the CC1310.

https://www.ti.com/lit/swra466

Cheers,

Marie H

0 Blake Carpenter 11 months ago in reply to Marie H

TI__Expert 7235 points

Thanks for the quick reply Marie! I have asked the customer for more detail and will reply if they have questions.

Blake

0 Blake Carpenter 11 months ago in reply to Marie H

TI__Expert 7235 points

Hi Marie,

The customer asks:

Do you know if we could modify somehow the FW offered by you and Stackforce to be able to configure T1 transmission or reception?

We can take this offline if you like.

Best Regards,

Blake

Sub-1 GHz

Sub-1 GHz forum

CC1310: Firmware upgrade methods?