CC1101 as a receiver for Remote Key Less Entry

Nilesh Kulkarni2

Expert 1120 points

Other Parts Discussed in Thread: CC1101

Hello All,

We want to develop RKE receiver with CC1101 as it support wake on radio feature.

Now we want to evaluate CC1101 and we have CC1101EMK433 x 2 and SmartRF05EB x 2.

Kindly let us know how we can proceed to use WOR feature with SmartRF05EB+CC1101EMK433

Awaiting for your valuable response.

over 10 years ago

0 PM over 10 years ago

TI__Mastermind 27145 points

Hi,
When you connect the board and open the SmartRFStudio, it detects the chip and it shows in the "List of Connected Devices".
Double Click on the Device, it opens up the "Device Control Panel" page. There are different tabs on that page and click on "RF Device Commands". You can see the commands there. Please note that you need to set all the required RF Parameters in "RF PARAMETERS" section.
Thanks,PM

0 TER over 10 years ago in reply to PM

TI__Guru**** 317180 points

Note that when testing WOR using SmartRF Studio you have to set the polling interval to never under the "settings" menu. If Smart RF Studio polls the chip it will exit WOR. For WOR testing test software is better than using SmartRF Studio.

0 Nilesh Kulkarni2 over 10 years ago in reply to TER

Expert 1120 points

Hello PM & TER,

Thanks a lot for your quick response.

Kindly let us know which software example should we use for WOR testing?

Awaiting for your valuable response.

0 TER over 10 years ago in reply to Nilesh Kulkarni2

TI__Guru**** 317180 points

We don't have any WOR examples for the platform you are using. One option is to start from the simplelink example found here: processors.wiki.ti.com/.../Category:Sub-1GHz for TRXEB and add WOR with the help of www.ti.com/.../swra126b.pdf

Sub-1 GHz

Sub-1 GHz forum

CC1101 as a receiver for Remote Key Less Entry