CC1310: Schematic Verification

Suresh Naga

Hello!

I'm trying to build a device withcCC1310 and made a schematic. Can you please have a look at it and give me some feedback?

Suresh

over 8 years ago

0 Eric Brundick over 8 years ago

Guru 12956 points

is 100K the correct pullup value for RESET_N? Also 100nF sounds too high for a pulldown... thought it was <=2.2nF?

0 Suresh Naga over 8 years ago in reply to Eric Brundick

Prodigy 230 points

Eric Brundick (1979788) , Thanks for swift response.

I took 1310 Launchpad as reference. That's why, the values are chosen to be 100k and 100nF. There're similar values in TIDU995D Should I change them to to 47k and 1nF?

Suresh

0 Eric Brundick over 8 years ago in reply to Suresh Naga

Guru 12956 points

Ah that is interesting, you're right, 100K pullup and 100nF pulldown cap. Not sure where I got the 2.2nF and 47K from, must've been from the MSP430 (those are correct values for MSP430 anyhow)...