CC1310: CC1310 PIN mapping to UART and Timers for PWM

Vikas Bhardwaj68

Part Number: CC1310

Hello,

I am designing customized board with CC1310 (CC1310F128RHB) and I would like to assign the PIN for UART , Timers and ADCs.

I went through the user manual & data sheet of CC1310, but there is no clue for DIO_X mapping with Pins of the CC1310 Pins, I am looking for supporting document for the same.

Regards,

Viaks Bhardwaj

Philips India.

over 7 years ago

0 Siri over 7 years ago

TI__Guru* 82501 points

Hi Viaks

Most of the peripheral ports can be mapped to any of the physical I/O pads.

Please download the CC13x0 SDK (http://www.ti.com/tool/SIMPLELINK-CC13X0-SDK) and look at the examples that are included. If you open one of the examples for the LaunchPad, you will have the file CC1310_LAUNCHXL.h included (Found here: C:\ti\simplelink_cc13x0_sdk_1_00_00_13\source\ti\boards\CC1310_LAUNCHXL). This file shows how the peripherals are mapped to the IOID for the LaunchPad. You simply must make a similar file for your project where you map the peripherals to the IOs you want to use on your HW.

Siri

0 Vikas Bhardwaj68 over 7 years ago in reply to Siri

Prodigy 20 points

@ BR Siri: thanks for the information!!

Sub-1 GHz

Sub-1 GHz forum

CC1310: CC1310 PIN mapping to UART and Timers for PWM