LAUNCHXL-CC1350: CC1350-Supported Camera module and GPIO configuration

Try to refer to www.sparkfun.com/.../9334

Thanks a lot YK, the page you forwarded is absolete/retired. Can you please send any active link for supported camera module for CC1350 LP.

Try this one at www.electronics123.com/.../c329-uart-board-color-jpeg-compression-vga-camera-module-no-lens-3136

Sudeept: I haven't loooked into what is possible here, what is the usecase?

Hi TER,

It's for surveillance solution, where we need camera streaming on CC1350 and process video on server.

Thanks,

Sudeept

According to my experience, it would be difficult for CC1350 to do video streaming because of RF bandwidth/speed.

Sudeept: Have you calculated which throughput you need in this application?

Hi TER,

We might be needing 10-15 sensors with camera connected in wireless n/w, video capture will be of QVGA (176x144) or SD (640x480) resolution.

Thanks,
Sudeept

What I asked is what throughput you need. Are you planning to have 1 fps, 10 fps, 24 fps for x cameras?

Also what range would you require?

Hi TER,

We are starting with 3-5 cameras, 24 fps capture rate, range will be approx. 150-200 meters.

Thanks,
Sudeept

The datarate with the highest throughput is 1.5 Mbps. The actual throughput is lower due to the the dividing of each picture into different packets.

640x480x24 = 7.4 M pixels pr second. Each pixel consist of more than one byte. Even with heavy compression I doubt that you will get sent even one camera stream.

Have you calculated which throughput you need for your application?

I think you have to use a video or image encoder to encode RAW data before sending it to CC13xx.