CC1101: How work with errata on datarate >250 kBaud?

Nazar Vozniy

Prodigy 80 points

Part Number: CC1101

Have a script / example on C where it is shown how to handle errata on fast data rate?

over 8 years ago

0 TA12012 over 8 years ago

TI__Mastermind 36395 points

Nazar,

Can you be more specific, here is a link to the errata, which one are you talking about?

www.ti.com/.../swrz020e.pdf

Regards,
/TA

0 Nazar Vozniy over 8 years ago in reply to TA12012

Prodigy 80 points

Usually Errata happen on data rate > 250 (400) kBaud for RX or TX?

0 TER over 8 years ago in reply to Nazar Vozniy

TI__Guru**** 317180 points

As far as I can see the errata note TA linked to does not mention data rate at all so which errata do you refer to? Please add a link and page number to the document describing it.

0 Nazar Vozniy over 8 years ago in reply to TER

Prodigy 80 points

This is taken from the practice of working with СС1101. On speed (data rate) less 128 kBaud - I not have errors. But when do data rate fast - have hangs.
One man from same forum said: You can have hangs (errors) when set fast data rate.
Он не прав?

0 TER over 8 years ago in reply to Nazar Vozniy

TI__Guru**** 317180 points

You should be able to do up to 500 kbps without issues.
- Do you use the SmartRF Studio recommended settings
- Do you see packet loss independent of signal level?

Sub-1 GHz

Sub-1 GHz forum

CC1101: How work with errata on datarate >250 kBaud?