CCS/LAUNCHXL-CC1350: How to send gpio led blinking or message from a sensors to the collector using the TI 15.4 stack

srilu

Part Number: LAUNCHXL-CC1350

Tool/software: Code Composer Studio

Hello,

I have done the given example program sensor and collector cc1350 temperature sensor but i want to do on gpio pin led blinking or message transfer from sensor board to collector board

so plz suggest me ...... how to write code

thank you in advance .......

over 7 years ago

0 YiKai Chen over 7 years ago

Guru 735685 points

In sensor example, it already shows you how to send message.

0 srilu over 7 years ago in reply to YiKai Chen

Prodigy 130 points

thanks for reply yikai chen
In sensor example i want to do change the message but i'm not getting where to change the message so plz suggest me ...

0 YiKai Chen over 7 years ago in reply to srilu

Guru 735685 points

You can change it in sendSensorMessage().

Sub-1 GHz

Sub-1 GHz forum

CCS/LAUNCHXL-CC1350: How to send gpio led blinking or message from a sensors to the collector using the TI 15.4 stack