CCS/CC1310: How to program the easylink concentrator and node?

When opening a new thread, you have to take into consideration that people reading this new thread have not read your other threads. If you write that you use an example, write the full name of this and which SDK version you are using. I assume from your previous posts that you are thinking about the wsn examples. I see that you have posted a lot of posts lately, could you outline what you are trying to implement?

Ok, you want to display temperature. Which temperature sensor are you planning to use? Does the built in BATMON have good enough resolution?

I have to do a project whereby the nodes will send infos such as temperature to the concentrater follwed by displayed on UART application in comp.And I need to control these commands using AT command like example if i use 2 sensors, then i control the sensors to send data upon command seperately

Start by doing dev.ti.com/.../prop_03_easylink_nwp.html

Then look into how to use the BATMON (several thread on the forum) works and alter the node code to send the data given by the BATMON.