LAUNCHXL-CC1352R1: How to set the order of channels in frequency-hopping

Thanks Edvard for your reply,
I think there should be a function at some layer at the stack that implements the DH1CF, I think I could write there my own sequence of channels to be accessed, do you get what I mean?
I think that this will be a hard way since there is not a ready function to use, but I am obligated to use this MCU to check the channels in specific sequence.

I would be grateful if you told me where to start from.

Regards
* James *

James,

The channel functions are implemented at the MAC layers of the TI 15.4-stack. You could theoretically overwrite/modify/add you own channel function at this level, but you will not get any support for modifying the lower layers of the TI 15.4-stack.

Can you make your own proprietary frequency hopping using the RF driver directly?

Evard,

Ok, if I have to do it through RF driver directly, what functions/configurations should I start with?

Also, if I switch to EasyLink (the example "dmm_wsnnode_remote_display"), can I use EasyLink_setFrequency() to set the frequency I'm using each time I'm sending/receiving ? Will that work?

Yes, you can use the EasyLink_setFrequency() before transmitting/receiving to tune into any specific frequency.

Thanks very much. One last thing, in the description of this function it says that the frequency will be rounded by the Frequency Synthesizer. How can I disable this synthesizer to use the exact frequency I set?

* James *

Thanks Tom for your reply.

OK. Is this synthesizer configurable? In other words, how can I set/know the frequencies that can be synthesized?

* James *