CC1310: How to evaluate +14dBm output on LAUNCHXL-CC1310 with SmartRF studio

Nomo

Part Number: CC1310

Hello,

Could you tell me the way to evaluate +14dBm output on LAUNCHXL-CC1310 with SmartRF studio?
My customers want to evaluate +14dBm output on LAUNCHXL-CC1310.
Should does they update the firmware to change CC1310 into the boost mode?
If yes, please let me know the procedure of the simplest way.

Best Regards,
Nomo

over 6 years ago

0 TER over 6 years ago

TI__Guru**** 317180 points

With SmartRF Studio you select the 14 dBm setting and all required bits etc are set so you are able to get 14 dBm out. The only thing you as user have to do is to select 14 dBm in SmartRF Studio.

0 Nomo over 6 years ago in reply to TER

Guru 16800 points

Hello TER-san,

Thank you for your reply.
However, they have not yet been able to see the 14dBm output.
(They've already checked the loss of path and the settings of the measurement equipment.
Could you share the data of measuring the output power?

Best regards,
Nomo

0 TER over 6 years ago in reply to Nomo

TI__Guru**** 317180 points

The data measured with this setting are shared in the datasheet.

- What do they measure
- How do they measure this?

Note that loss in the cable between the DUT and the spectrum could be between 0.5 and 1 dB.

0 TER over 6 years ago in reply to TER

TI__Guru**** 317180 points

Closing this thread due to inactivity.

0 Nomo over 6 years ago in reply to TER

Guru 16800 points

Hello TER-san,

I apologize for being late on this thread.
I could not get any feedback from my customers.
I close this thread, and if I have any additional questions I will make another post.

Best Regards,
Nomo

Sub-1 GHz

Sub-1 GHz forum

CC1310: How to evaluate +14dBm output on LAUNCHXL-CC1310 with SmartRF studio