CCS/LAUNCHXL-CC1352R1: is rfpacketTx example packet only sensed by smartRf studio?

user5862720

Expert 1300 points

Part Number: LAUNCHXL-CC1352R1

Tool/software: Code Composer Studio

hi~

i made float tpye packet array in rfpacketTx example

it received by smartRf studio well .

but if i attempt to received another program (visual studio c++ serial communication)

it can't receive.

so i doubted if this rfpacketTx example only sna recieved by smartRf studio.

over 6 years ago

0 IUsedToBeARealPerson (M-W) over 6 years ago

TI__Guru 58425 points

Hi,

I'm not sure what the issue is, could you elaborate? I assume you are sending data from rfPacketTx to SmartRF Studio, why do you expect to be able to also receive the data with a serial tool such as the "VC C++ serial communicator"?

0 user5862720 over 6 years ago in reply to IUsedToBeARealPerson (M-W)

Expert 1300 points

hi~ thanks for comment .
the issue is packets that generated by rfpacketTx example can be received only SmartRF Studio or rfpacketRx example ?

0 TER over 6 years ago in reply to user5862720

TI__Guru**** 317180 points

Given the same settings used in the example and SmartRF Studio, both SmartRF Studio and rfpacketRx should be able to receive the packet sent by the tx example.

What exactly is " received another program (visual studio c++ serial communication)"?

0 user5862720 over 6 years ago in reply to TER

Expert 1300 points

hi~ my problem is ..
i have two device and want to communicate between two launchpad.
is it possible that transter data to other devices uart port ? like com20->com22
(only one device can debug with ccs and i dont know how ohter device can receive that)

0 TER over 6 years ago in reply to user5862720

TI__Guru**** 317180 points

Is your purpose to debug both the TX and RX side at the same time? A normal flow would be to debug either RX or TX and then use SmartRF Studio as a know good software on the RX or TX side.

0 user5862720 over 6 years ago in reply to TER

Expert 1300 points

yes that's my purpose.you means ,it it impossible to debug two launchpad(one is for tx,another in for rx) in sametime in ccs ?:)

0 TER over 6 years ago in reply to user5862720

TI__Guru**** 317180 points

No, but than you need two CCS running, one with a TX project and the other for a RX project.

0 IUsedToBeARealPerson (M-W) over 6 years ago in reply to TER

TI__Guru 58425 points

Hi,

It is actually possible, have a look at this (the guide is not for our device directly, but you should be able to follow the over all idea):

software-dl.ti.com/.../sdto_ccs_multi-probe-debug.html

Sub-1 GHz

Sub-1 GHz forum

CCS/LAUNCHXL-CC1352R1: is rfpacketTx example packet only sensed by smartRf studio?