RTOS/CC1310: External pin control transmission

Yes, this is possible depending on how you get the data. If you get "packets" on the serial interface this is not an issue, if you actually get a continuously stream on the UART you have to send the incoming data with higher datarate that the baud rate to ensure that you have time to divide the incoming data into data packets.

Hi TER,
The data rate I am using is 50kbs. Are you sure this method is OK? I mean that when the pin output is high, the RF core is always in the transmit state (not triggered). In the code, I don't need to fill the packet and execute runcmd, but directly put the UART. Data is transmitted automatically to the RF core via hardware. Does the CC1310 have this feature?

You have to make a program that does this.

In the task I only need to execute runcmd?

Ok，I have seen this code before.I have three questions now.
1.If I set the UART software ringbuffer size to 32Bytes, the serial port receives 256 bytes at a time, then the chip will be stuck?
2.Does the serial port's ringbuffer have the function of counting the number of bytes received?
3.How to divide serial port data packets?

Hello?

Closing this thread since you have opened a new one here: e2e.ti.com/.../783692

ok