LAUNCHXL-CC1350: CC1350 contiki webdemo-router

Try to add #define NETSTACK_CONF_RDC nullrdc_driver in radio node and router's project-conf.h and rebuild them to test again.

I tried it that you saw but it doesnt' work.

How can I do

It doesnt't work the multihop, that is with lynx [bbbb::100] I can see both but cc26xx-web-demo doesn't act as router , but like a node, despite in the code of cc26xx-web-demo there is a simple code:

#ifdef RPL_CONF_LEAF_ONLY
#define RPL_LEAF_ONLY RPL_CONF_LEAF_ONLY
#else
#define RPL_LEAF_ONLY 0
#endif

 how can i do?

But my firmware of the radio node is based on contiki 3.0 . It s a problem ?

Which is the right command to create .bin of cc26xx-web-demo?

How can i do?

Try to refer to to run CONTIKI-NG

I did it and I compiled it. But i have a question:
Is a problem if my firmware(of radio node) is  a platform in contiki 3.0 and not contiki -ng?

I couldn’t understand your question.

thanks for your fast reply Yikai

I resolved in partly th problem. I put (without router contiki ng):

- slip-radio+BBB close to my pc

- radio node situated 12 metres from my pc

Result: with lynx [bbbb::100] I can't watch anything

I put :

- slip-radio+BBB close to my pc

- router situated 6 metres from my pc

- radio node situated 12 metres from my pc

Result: with lynx [bbbb::100] I can watch both radio node and router.

Problem: when I leave my script in python to start the communication between node and BBB the packets didn't sent.

Why?

Which is the problem?

But does the router acting as a router?

Thanks in advance

What do you mean "I leave my script in python to start the communication between node and BBB"?

I open the PuTTy:

I throw the communication between radio node and border router(slip radio). My node is connected to a sensor and it sends a messages like temperature pressure, ecc. trhow JSON string. But the communication doesn't start, despite with lynx I can see both radio node and router.

Why?

How can I do?

I still couldn’t understand your question. Can you do some screenshot or pictures to show me your test?

I realize one mesh network composed of:
-Border Router+ Gateway= CC1350(slip radio)+BBBWireless: On my PC
-Router= CC1350(cc26xx-web-demo, contiki-ng):5 metres from my pc
-Radio Node=CC1350(firmware of mine that send MQTT messages to my BBB) 12 metres form my pc
Now If I take out the router with lynx [bbbb::100] I don't se anything nor the router and nor the radio node.
Instead If I put the router I see all with lynx, but the radio node doesn't send MQTT messages.
The IPv6 address of node is always the same or with or without router.
Anyone could give me any suggestion?
Thanks in advance

I tried to help you in your another similar post.