CCS/LAUNCHXL-CC1352R1: Sensor BoosterPack with CC1352R1

Juan Carlos Martin

Part Number: LAUNCHXL-CC1352R1
Other Parts Discussed in Thread: TMP116

Tool/software: Code Composer Studio

Hi.

I have the Sensors BoosterPack and I'm trying to measure the temperature and the oscilation of the board (CC1352R1).

My problem is that I only see examples with the board MSP432P401R, example called "boostxl_sensors_sensorgui_msp432p401r_MSP_EXP432P401R_nortos_css". I tried to start a new proyect changing some libraries but it doesn't work.

over 6 years ago

0 Fredrik K over 6 years ago

TI__Guru** 106705 points

Hi Juan,

You can refer to this example: dev.ti.com/.../node

Regards,
Fredrik

0 Juan Carlos Martin over 6 years ago in reply to Fredrik K

Intellectual 350 points

Hi Fredrik,

I use that example before posting and I got a problem, it doesn't work. I put the sensors boosterpack on the board, run the example... And nothing... Serial port says:

I2C Initialized.

I2C Bus fault.

....

The example is for TMP116 and the sensor has TMP007, the address of TMP116 is 0x48 and for TMP007 is 0x40, i tried it but I had the same error.

0 Fredrik K over 6 years ago in reply to Juan Carlos Martin

TI__Guru** 106705 points

Hi Juan,

Have you verified that you initialize the TMP007 correctly? Have you verified that the code reads from the correct registers in the TMP007? Have you looked at the I2C bus with a logic analyzer?

Regards,
Fredrik

Sub-1 GHz

Sub-1 GHz forum

CCS/LAUNCHXL-CC1352R1: Sensor BoosterPack with CC1352R1