CC1310 How to enter in sleep mode

TI-RTOS ensure that CC1310 is in the lowest possible power state at a given time. If you draw current in the mA range it sounds like you have not implemented your application a way that allows low power consumption. 

If you are just waiting to press a button and nothing else is running it should be possible to get down in the low uA range. You can look at the current consumption in the following example: http://dev.ti.com/tirex/explore/node?node=AD4C-4qDAksNgP7h5SzXdA__eCfARaV__LATEST which is half of what you need. 

Hi TER, Thank you for your reply. Within the project, what I do is send a command via RF communication when the button is pressed. However, consumption is high. It's how the receiving part is always active.

From the description I assume that your remote is primary a sender, sending a RF packet when the button is pressed. Why is the remote in cont. RX? 

Yes I have a remote control and a RX. When I push the button I send a command RF. How to enter in standby mode when I not pushed the button?

Have you looked through http://dev.ti.com/tirex/explore/node?node=ACWKlMgmt3t0rDA6.a7c8Q__eCfARaV__LATEST and the the TI-RTOS training? 

Yes! I using TIRTOS. The my remote control consumes about 7 milliamps, because it always has the active reception part. How can I put this sleeper?

Have you looked through http://dev.ti.com/tirex/explore/node?node=ACWKlMgmt3t0rDA6.a7c8Q__eCfARaV__LATEST and the the TI-RTOS training? 

If you have read the provided documentation you should have found the answer to your question. 

I read this : http://dev.ti.com/tirex/explore/content/simplelink_academy_cc13x0sdk_3_20_01_00/modules/sensor_controller/sc_02_ulpsense/sc_02_ulpsense.html with the section how to create an application in low power, but i don't understand how to implement this in my project. Can you help me?

TER I found your example of RF UART communication. I see that the part of receiver consuming 7.4 mA even when it receives nothing.  

There is a function that allows you to do this:

when it receives nothing, turn off the radio, otherwise if you receive it, turn on the radio.

I saw a function called RF_yield that turn off the radio manually. It's correct this function for the example that I told you?

It's different ways to do this, you can also use a end trigger which times out the command. But first you have to figure out how you are going to have the radio in receive when you press send on your remote. Normally a key press can happen at any time, meaning that the radio has to be in RX all the time. You can look into http://dev.ti.com/tirex/explore/node?node=AG60UNShqVxqVw-H5Tu.pA__eCfARaV__LATEST as one example 

It possible to implement a Pin_shutdown in your RF example? 

It should be possible in combination with http://dev.ti.com/tirex/explore/node?node=AHcZnJ1hfWGdU.lNFSFShA__eCfARaV__LATEST