Footprints and symbols for CC Antenna DK kit2

Vijayasarathy N

Hi TI Champs.

Have one request.

I would be a great help and service to our TI hardware developers and IoT makers if you folks could enable TI antenna symbols and footprints, available as .bxl files.

This will help us to reuse the same in our CC13xx, CC12xx designs without worrying about reconstructing a new antenna, everytime for a new project.

Thanks in advance.

Best Regards

over 6 years ago

0 PM over 6 years ago

TI__Mastermind 27145 points

Hi,

I informed the concerned engineer and we will get back to you ASAP. Please bare with us.

Thanks,

0 RGW over 6 years ago

TI__Mastermind 33660 points

Hi,

Currently, we do not have the opportunity to convert the antenna reference design files to *.bxl files.

This is good input for future reference antenna designs that we will take into account when releasing new designs.

The majority of our antenna designs are monopole which are dependent on the GND plane size. The exact length of the monopole will always be relative to the GND size so there will always be a certain "flexible" length required for each antenna.

Thanks,

Richard

0 Vijayasarathy N over 6 years ago in reply to RGW

Intellectual 285 points

Hi Richard

Thanks for the update.

Best regards

Sub-1 GHz

Sub-1 GHz forum

Footprints and symbols for CC Antenna DK kit2