porting CC3000 to a different MCU

Shlomi Itzhak

Guru 61565 points

What do I need to do in order to port the CC3000 host driver to a different MCU?

over 13 years ago

0 Igor56492 over 13 years ago

TI__Intellectual 1735 points

The CC3000 host driver code is platform independent except the SPI layer that has different implementation on every MCU. For more information please refer to the CC3000 Host Driver Porting Guide: http://processors.wiki.ti.com/index.php/CC3000_Host_Driver_Porting_Guide

0 Dh Sh over 13 years ago in reply to Igor56492

Intellectual 645 points

Hi,

What about the HW? Can I use the same FRAM kit and do some blue wiring to pull the SPI lines out? It seems very different type of connector. Any idea?

0 Igor56492 over 13 years ago in reply to Dh Sh

TI__Intellectual 1735 points

Hi,

I think u can try to bluewire to the 2 headers that are on the FRAM boards and provide access to the PIN's themselves.

Please note that you can not both connect to the RF1/2 connector and to perform blue wiring (at the same time of course)

Regards

Wi-Fi

Wi-Fi forum

porting CC3000 to a different MCU