WL1831 bt and ble coexistence RF testing

Aashish Patel

Other Parts Discussed in Thread: WL1831

Hi All

We are doing rf testing on custom board with Wl1831 on it. We have tested wlan, bt, and ble separately using Hci commands and got proper results.

Now we want to test bt and ble coexistence testing

Is there any command to enable bt and ble simultaneously and test?

over 10 years ago

0 Sundeep Javvaji over 10 years ago

TI__Mastermind 32615 points

Hi,

Could you please let me know what is the test case?

0 Aashish Patel over 10 years ago in reply to Sundeep Javvaji

Intellectual 690 points

Hi sundeep
One of the use care is A2DP(bt) alongwith
Hogp(ble)
Test case is to check whether communication through both at the same time cause any issue?? (eg. Reducing power level or Packet Loss in either BT or WLAN). If yes, in which data rate it will affect the max power? In which data rate, it will affect the min power?

0 Sundeep Javvaji over 10 years ago in reply to Aashish Patel

TI__Mastermind 32615 points

HI,

Please see the inputs i have received internally:
General it should not cause any issue, The priorities in this scenario would first be to the A2DP, and only then to BLE.
Testing coexistence is not possible in “test mode”. Coexistence is supported in real operational environment

Wi-Fi

Wi-Fi forum

WL1831 bt and ble coexistence RF testing