BTS firmware for wl18xx chip

Hi Sundeep,

Thanks!

But I am not able to scan and list any devices, following is the op:

# hciconfig -a hci0
hci0: Type: BR/EDR Bus: UART
BD Address: 34:B1:F7:E2:DE:CB ACL MTU: 1021:6 SCO MTU: 180:4
UP RUNNING
RX bytes:357 acl:0 sco:0 events:13 errors:0
TX bytes:58 acl:0 sco:0 commands:12 errors:0
Features: 0xff 0xfe 0x2d 0xfe 0xdb 0xff 0x7b 0x87
Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3
Link policy:
Link mode: SLAVE ACCEPT
Name: ''
Class: 0x001f00
Service Classes: Unspecified
Device Class: Invalid Device Class!
HCI Version: 4.0 (0x6) Revision: 0x0
LMP Version: 4.0 (0x6) Subversion: 0xac20
Manufacturer: Texas Instruments Inc. (13)


Thanks And Regards,
Mike

Hi Sundeep,

By any chance does scan only work with antenna connected ? I felt wli18xx had a internal antenna ?

Thanks And Regards,
--Mike

Hi,

No. But the range will be very less. yes the COM8 has internal antenna, but by default the antenna configuration is mapped to U.FL (external) connector (C7 and C8 are connected). which as to be changed to C5 and C6 capacitors, for routing it to internal antenna.

Make sure that the page and inquiry scans are running (enabled)

Please make sure you are using the right service pack from here git.ti.com/.../master.

Hi Sudeep,

How to enable page and inquiry scans are running ? there isnt any proper documentation on doing all the stuff
unless I am missing something.

Thanks And Regards,
Mike