Program Flash of CC3200 Launchpad using Code Composer Studio

gchaconr

Other Parts Discussed in Thread: CC3200, UNIFLASH

Hi, I am able to debug certain code in the CC3200 Launchpad using CCS, but once I stop the debugging procedure the code does not get stored in the flash.

I was able to load the code using UniFlash, but I am wondering if there is a way to do it only using CCS for debugging and loading the code permanently in the memory flash.

Thanks in advance for any suggestion you could provide.

Best regards.

over 10 years ago

0 Glenn Vassallo over 10 years ago

Guru 21435 points

No.

You use CCS for debug, this will only run the program in the CC3200's RAM. In other words volatile memory.

You use UniFlash to copy the application to the serial flash. when booting (if SOP 2 jumper is removed) it will look for application saved as /sys/mcuimg.bin and load this into the CC3200's RAM.

Glenn.