CC3200MOD Design Files for Mentor Graphics PADs Layout

Kevin Stevens

Other Parts Discussed in Thread: CC3200MOD

Does anyone have the .pcb file for the launchpad or anything that has the antenna section. I have been trying to convert the Allegro files for an hour to no avail. I can view the Allegro file and have attempted the PADs import instructions and get an error indicating that the "Job is not compatible with current version of program!" when I try to open the converted file. I have also tried to get a .dxf of the file and just import that and nothing is working. I would appreciate any help.

over 10 years ago

0 Prajay Madhavan over 10 years ago

TI__Genius 11120 points

I am sorry that we do not have a .pcb (PADs file ) for the board. But I am providing you an older version of the file. Please check if you can import that.CC3200-LAUNCHXL_SCH_LYT_REV4P1-A_16P2.zip

0 Kevin Stevens over 10 years ago in reply to Prajay Madhavan

Intellectual 350 points

Thanks for the effort, but that didn't make much of a difference. I was however, finally able to get the file exported as a DXF and imported into PADS as lines. I can now at least trace over the design and get pretty close. If anyone does have a PADS design of the CC3200MOD I would still appreciate that.

Here is the DXF file and the PADS import I created. Hopefully these save someone else some time.CC3200MOD.zip

0 Prajay Madhavan over 9 years ago in reply to Kevin Stevens

TI__Genius 11120 points

Kevin
Thank you so much for sharing your design online. This will help a lot of people on the forum.

Wi-Fi

Wi-Fi forum

CC3200MOD Design Files for Mentor Graphics PADs Layout