Other Parts Discussed in Thread: WL1835MOD
Hello TI Expert,
I have got a question from our customer about the WL1831MOD RF_ANT2.
Our customer has designed their own board by referring to the WL1835MOD reference schematics.
If they use WL1831MOD, is it good that RF_ANT2 is not connected? Or, any pullup or pulldown is needed?
Please let me confirm whether RF_ANT2 can be Not Connected.
In this case, if there is only RF_ANT1 pattern of WL1835MOD on their custom board, can they get a certification from FCC/TELEC?
Thank you for your advice.
Best Regards,
Nobu Arai