CC3200-LAUNCHXL: Compatibility of cc3200 with MSP430F5438A

SHIVA PJ

Part Number: CC3200-LAUNCHXL
Other Parts Discussed in Thread: CC3200, MSP430F5438A, UNIFLASH

Hello sir,

1). We would like to know that can we transfer PCB393B12 (Accelerometer) sensor data using MSP430F5438A+CC3200 (Wifi Module) to another setup of same configuration?

2). If possible, plz guide us regarding interfacing of CC3200 with MSp430F5438A, Also Transferring UART data using Wifi Module i.e. CC3200?

Thanks in Advance...

over 7 years ago

0 made4engineering over 7 years ago

TI__Mastermind 27605 points

Hi Shiva,

For a CC3200 uart example, look in the SDK for uart_demo.

-Aaron

0 SHIVA PJ over 7 years ago in reply to made4engineering

Expert 1430 points

hello sir,

I uploaded tcp_socket example to cc3200 , and cc3200 is connecte to my hotspot it is fine but when i poweroff and i powerup the board it is not connecting to the hotspot why this is.

0 Jan D over 7 years ago in reply to SHIVA PJ

Guru 79905 points

Hi,

Using JTAG you can load code into RAM. After power off is this code gone. If you need code which persists restart, you need upload code into flash using Uniflash software (version 3.4).

Jan

0 SHIVA PJ over 7 years ago in reply to Jan D

Expert 1430 points

sir,

i tried to program with uniflash, it is uploading the program but not executing

0 Jan D over 7 years ago in reply to SHIVA PJ

Guru 79905 points

Hi,

As first steps:
- format sFlash
- upload service pack
- program using button "Program"
- disconnect SOP2 jumper and reset device

Jan

Wi-Fi

Wi-Fi forum

CC3200-LAUNCHXL: Compatibility of cc3200 with MSP430F5438A