CC3220MOD: Max current consumption

Hisao Uchikoshi

Part Number: CC3220MOD

Hi Experts,

The datasheet specification describes the current consumption for typ only. Do you have any max value for current consumption?

We have to estimate the max current consumption.

Regards,

Uchikoshi

over 8 years ago

0 Tom Roberts over 8 years ago

Expert 1155 points

Hi,

I believe in Section 4.5 of Datasheet, it shows the Peak Calibration Current of 450mA @ 3.3V
was that what you were looking for?

Regards, Tom

0 Hisao Uchikoshi over 8 years ago in reply to Tom Roberts

TI__Genius 15680 points

Hi,
The Peak calibration current stands for the current consumption during calibration thus it is not what I want to know.

Regards,
Uchikoshi

0 Benjamin Moore over 8 years ago in reply to Hisao Uchikoshi

TI__Mastermind 31055 points

Hi Uchikoshi,

Please clarify what you mean by "max current consumption". It sounds like you are referring to a specific mode of operation or use case since you aren't looking for just the peak. Typically the peak value is referenced when designing the rest of the system (power supply).

If you're looking for estimating something like battery life -> The average power consumption will vary depending on the overall system (what AP the system connects to, which power profiles are used on the device, which networking applications are used, etc.). It is difficult to provide a maximum for this, so a typical value is what we provide in the datasheet. A worst case should be determined experimentally.

Best Regards,
Ben M

0 Hisao Uchikoshi over 8 years ago in reply to Benjamin Moore

TI__Genius 15680 points

Hi Ben,

Thank you for your answer.

Regards,

Uchikoshi

Wi-Fi

Wi-Fi forum

CC3220MOD: Max current consumption