Linux/WL1837MOD: CONTINUOUS WAVE MODE SETTINGS FOR WL1837MOD

Please, follows the procedures described here-

processors.wiki.ti.com/.../WL18xx_Bluetopia_PM_Bluetooth_RF_Testing

Thanks

Thanks Hari for your quick help.

The link you mentioned is for Bluetooth, right ? If yes, then is it applicable for WiFi as well ?

I need to do the settings for WiFi for continuous wave mode. Please share the details to put mentioned  WiFi chip in continuous wave mode

I have found this link : processors.wiki.ti.com/.../WL18xx_TX_Testing

In that I have taken the reference of 'TX Tone Test' for the continuous mode testing and have placed the following lines in the shell-script and executed that,
calibrator wlan0 plt power_mode on
calibrator wlan0 wl18xx_plt tune_channel 11 0 0
calibrator wlan0 wl18xx_plt tx_tone_start 2 0 2 1
calibrator wlan0 wl18xx_plt tx_tone_stop

Does it solve the purpose of Continuous Wave mode testing ?

Thanks Saurabh for the support,

I have tried the 'Tx Continuous' test with the following commands in the shell script,
--------------------------------SHELL SCRIPT----------------------------
calibrator wlan0 plt power_mode on
calibrator wlan0 wl18xx_plt stop_tx
calibrator wlan0 wl18xx_plt tune_channel 11 0 1
calibrator wlan0 wl18xx_plt set_tx_power 20000 1 0 11 0 3 0 0 0 0 0 0
calibrator wlan0 wl18xx_plt start_tx 100 11 500 0 0 1 0 2 <SOURCE MAC ADDRESS> <DESTINATION MAC ADDRESS>


However I have managed to capture the output of each command via '$?',
---------------------------------------Output------------------------------------------
240
0
0
0
1


I guess the above output are not desirable.
Please let me know the another way to make it work if the above output shows otherwise.

Hi,
can you pls confirm if it works with example arguments mentioned on wiki ?

Saurabh