BOOSTXL-CC3135: SPI Programmer - Recommendation

He Hnz,

Thanks for your reply.

So, I can proceed with Cheetah SPI and it is also easy available at my location.

Regarding the connector (J1) for which the BOOSTXL-CC3135 has been designed, I need to know the part number of the cable to connect with the J1 part for SPI flash.

So, one end of the cable shall be sitting on the BOOSTXL-CC3135 board and other end on the SPI programmer.

Hi,

I think this is proprietary connector layout and you will not able able buy them. Nothing prevent you create this connector by yourself. It is pretty easy job with few pogo pins. But you can wait for answer from TI regarding connector.

In case you want to use BOOSTXL-CC3135 why you not use programming via UART and CC31XXEMUBOOST? Why you want to use direct programming via SPI?

Jan

Hi,

We have bought cheetah spi programmer and before starting the flashing, we need some parameters to be provide in the s/w tool.

1.Baud rate(SPI speed)
2.Bit order (LSB or MSB)
3.ss polarity(high or low)
4.spi mode

what are the values we need to provide for the CC3135MOD to flash.

let us know asap.