This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.


Part Number: BOOSTXL-CC3120MOD
Other Parts Discussed in Thread: CC31XXEMUBOOST, UNIFLASH

Hi TI.

I prepared two pairs of the following products.

I would like to use TRANSCEIVER Mode with this one.

1. How to set the Tranceiver mode on the BOOSTXL-CC3120MOD?
    In UniFlash, only AP/STA/P2P can be set for Device Mode.
    And any examples of Tranceiver mode?

2. Is there any RF Tranceiver mode example provided by MSP-EXP432P401R?

Thank you in advance.



  • Hi Simon,

    Please see chapter 13 of the CC3x20, CC3x3x Network Processor Programmer's guide here:

    Specifically, please see the note in section 13.3 -

    "To use transceiver mode, the device must be set in STA role, be disconnected, and have disabled previous connection policies that might try to automatically connect to an AP."

    The power_measurement example from the plug-in supports an option to run the device in Transceiver Mode. Check out the README.html file included in the power_measurement demo folder for details.

    Best Regards,

    Ben M