CC2652P: How to perform an RF test

Hi Ryan，

1、I use ZNP to test tx power, what command should I send？

2、If I use SmartRF Studio 7 to test, do I need a specific demo?

BR

Victor

Hi YiKai，

1. You can use SYS_SET_TX_POWER to set ZNP tx power in dbm.

→Do I need to keep sending TX data during testing? I still have a question about how to start TX Test using Z-tool，or we have to use SmartRF Studio to test.

Our RF engineers need to test the signal indicators.

Only need to use SYS_SET_TX_POWER to set ZNP tx power in dbm one time before your test TX power. By the way, I would suggest you to use SmartRF Studio to test TX power which is much easier than using ZNP.

OK. I will use SmartRF Studio.

Jtag and uart is necessary, right? 

Hi  YiKai,

Thanks  a  lot!

BR

Victor