CC2530: how to clone a zigbee coordinator using ZTool

siddharth sahu

Prodigy 85 points

Part Number: CC2530
Other Parts Discussed in Thread: Z-STACK

i have try https://sunmaysky.blogspot.com/2016/01/how-to-clone-existing-z-stack.html?m=1

1.i dont know how to Enable Compiler option MT_SYS_KEY_MANAGEMENT on coordinator

2.i have try all the configuration id and read the NVM and rewrite to new coordinator except the one cmd

ZCD_NV_TCLK_TABLE_START(0x0101) because when i read config id (0x101 or 0x111) from NVM it shows invalid parameter

please YK help me what to do does TCLK table is important to make clone of a coordinator

over 3 years ago

0 YiKai Chen over 3 years ago

Guru 735695 points

1. Do you add MT_SYS_KEY_MANAGEMENT in ZNP project and rebuild it to get ZNP hex file to download into CC2530?
2. You should use 0x111 for ZCD_NV_TCLK_TABLE_START

Can you attach your ZNP with MT_SYS_KEY_MANAGEMENT defined for me to test it?

0 siddharth sahu over 3 years ago in reply to YiKai Chen

Prodigy 85 points

dear YK

please tell me how to rebuild and what tool should i use to rebuild , ZNP hex file to download

0 YiKai Chen over 3 years ago in reply to siddharth sahu

Guru 735695 points

You can open ZNP project with IAR to rebuild ZNP hex file and download it to your CC2530 with CC DEBUGGER. By the way, you can refer to Z-Stack example developer guide in Z-Stack folder to show you how to use IAR to build Z-Stack examples.

0 Ryan Brown1 over 3 years ago in reply to siddharth sahu

TI__Guru**** 219527 points

A similar issue is being discussed in https://e2e.ti.com/f/1/t/1077598

Regards,
Ryan

Zigbee & Thread

Zigbee & Thread forum

CC2530: how to clone a zigbee coordinator using ZTool