(CC2562P) Don't receive the trasport key when device joins.

If the device had rejoined the network, you won’t get transport key. Make sure you remove the device completely and join the device to Zigbee network from scratch.

The device joining is a new device.

Do you try to factory reset your coordinator to test again and can you attach your sniffer log?

Sniffer.rar

Here is the sniffer log. Channel 15. Wireshark file and ubiqua file. i joined a temperature sensor

Forgot to mention: Firmware ZBoss Sniffer

Looks like you had the same problem as me. 

What you should do now is find a new device to check if it can join the network

You mean try to join a device different from the temperature sensor?

Sure I can try with a thermostat

Don't get the trasport key either.

I mean you should find another end device and try allowing it to join the network to see if you get the transport key.

By pairing a NodOn Device I received the Trasport Key. Maybe the thermostat and temperature sensor are HA Devices?

Looks like it is very randomic when i receive the trasport key and when not.

Tried to join the NodOn once again, after resetting it, but didn't receive the trasport key.

Maybe the key has been transported but you can't sniff the packet

Hi Luca,

What is the short address of the device in question on your sniffer logs?  Have you debugged ZDSecMgrDeviceJoin->ZDSecMgrSendNwkKey on the ZNP/ZC device?  Does the device send data requests/packets which are acknowledged in the network?  How close is your sniffer to the ZNP/ZC?  It's possible that your sniffer is missing packets as indicated by the sequence numbers of the Trust Center.

Regards,
Ryan