CC2651P3: Problem adding MT to Zigbee 3.0

Carlos Ferrer

Part Number: CC2651P3

Following the MT inerface tutorial, https://dev.ti.com/tirex/content/simplelink_cc13xx_cc26xx_sdk_6_40_00_13/docs/zigbee/html/zigbee/mt_interface.html, trying to build the proyect.

Shows this problem:

I've benn looking for solution in the forum with no succed.

Thanks

10 months ago

0 Ryan Brown1 10 months ago

TI__Guru**** 202256 points

Hi Carlos,

You should remove the MT_GP_CB_FUNC pre-defined symbol.

Regards,
Ryan

0 Carlos Ferrer 10 months ago in reply to Ryan Brown1

Prodigy 60 points

I did it, but nothing has chage, same error

+1 Ryan Brown1 10 months ago in reply to Carlos Ferrer

TI__Guru**** 202256 points

I tested a default zed_sw project with MT added according to the instructions provided, so I am surprised to hear that it still does not work. I recommend cleaning your project and removing gp_TaskID along with other MT GP resources if Green Power is not needed for your application.

Regards,
Ryan

0 Carlos Ferrer 10 months ago in reply to Ryan Brown1

Prodigy 60 points

One question more, is Z-tool available for al TI devices?. I'm having problems to found my device from Z-tool 2.0 in my pc. But I can comunicate with putty from my pc.

I've been looking in to the forum and trying different things an nothing has change.

Is posible that the problem is my device, or the zed_sw project.?

0 Ryan Brown1 10 months ago in reply to Carlos Ferrer

TI__Guru**** 202256 points

Z-Tool is available from <sdk_source>\tools\zstack\ztool and you will need to modify the baud rate to 115200 (no CTS/RTS flow control) from the Application UART COM Port of your device from the Z-Tool -> Tools -> Settings -> Serial Devices -> Edit window. This is not affected by your CC2651P3 device and no additional changes to the zed_sw project are required.

Regards,
Ryan

0 Carlos Ferrer 10 months ago in reply to Ryan Brown1

Prodigy 60 points

Still having same error, No device detected

0 Carlos Ferrer 10 months ago in reply to Carlos Ferrer

Prodigy 60 points

My pc is conected to the board by de USB cable, Is posible to be that the problem?

+1 Ryan Brown1 10 months ago in reply to Carlos Ferrer

TI__Guru**** 202256 points

A standard USB cable should be fine. Are you able to view the LaunchPad as an Application/UART COM Port inside your PC Device Manager? Can you verify Z-Tool operation using the default ZNP firmware? If this succeeds then maybe try a ZR or non-sleepy ZED to determine whether this affects behavior. Also verify the genericapp migration which is referenced in the MT Guide. You will either have to 1. Define CUI_DISABLE (I understand that this is counter-intuitive to the instructions provided) or 2. remove the SampleApp UI files and usage inside of zcl_samplesw.c/h since the UART lines are intended for the MT interface instead. If you open the COM port in a serial terminal such as PuTTY or TeraTerm you may even see the UI populating the Application UART COM Port. After defining CUI_DISABLE I could get my zed_sw project's MT interface to be detectable from Z-Tool

Regards,
Ryan

0 Carlos Ferrer 10 months ago in reply to Ryan Brown1

Prodigy 60 points

Defining CUI_DISABLE solve all the problems.

Thank's so much for your time

Zigbee & Thread

Zigbee & Thread forum

CC2651P3: Problem adding MT to Zigbee 3.0