CC2651P3: Ztool, toogle on/off

Carlos Ferrer

Prodigy 60 points

Part Number: CC2651P3

I have two ED, one is a switch and other a light. I can toogle the light from the sw using AF_DATA_REQUEST.

If I bind both endpoints and cluster, how can I activate the specific cluster in the sw from Ztool?

over 2 years ago

0 YiKai Chen over 2 years ago

Guru 735695 points

Send binding request to switch and set light ieee/short address and endpoint as binding destination.

0 Carlos Ferrer over 2 years ago in reply to YiKai Chen

Prodigy 60 points

Okay, I already binded both devices. Know wich comad do I have to send to the sw from Ztool to activate the cluster?

0 Ryan Brown1 over 2 years ago

TI__Guru**** 221027 points

Hi Carlos,

What are you ultimately attempting to accomplish with binding? What do you mean by "activate the cluster"? You've already stated that the switch can toggle the light. Do you want to use indirect addressing mode?

Regards,
Ryan

Zigbee & Thread

Zigbee & Thread forum

CC2651P3: Ztool, toogle on/off