CC2652R7: Loading Programm to custom board (without xds110)

Sarbjeet Singh

Part Number: CC2652R7
Other Parts Discussed in Thread: , UNIFLASH, SEGGER

Hello E2E team,

We need to design IoT solutions using cc2652R7, but unable to Load Programme without XDS110 debugger ... we using LP-2652R7 Lauchpad for reference..and trying to flash a simple blink code by JTAG only....

Please help us with that...

over 2 years ago

0 Ryan Brown1 over 2 years ago

TI__Guru**** 219597 points

Hello Sarbjeet,

What programming tool are you using if not the XDS110? Here is a list of options, and you can also refer to OpenOCD for an open source JTAG solution. Or perhaps you would like to consider the Serial Bootloader Interface.

Regards,
Ryan

0 Sarbjeet Singh over 2 years ago in reply to Ryan Brown1

Prodigy 50 points

Hello Ryan,

Thank you for the quick response. Currently tried to upload code to LP-cc2652R7 with JTAG pins only. For that we used Code Composer Studio and also Uniflash but is it a must to have XDS110....Thank you

0 Sarbjeet Singh over 2 years ago in reply to Ryan Brown1

Prodigy 50 points

Hello Ryan,

We are using Segger J-Lnk probe (programming tool) for JTAG connection and used Uniflash and also Code Composer Studio as software tools .....

0 Ryan Brown1 over 2 years ago in reply to Sarbjeet Singh

TI__Guru**** 219597 points

Segger should have more information on this: https://segger.com/products/debug-probes/j-link/technology/ides/ti-code-composer/

You should be able to search for similar instances of relevant E2E threads or utilize the Segger forum. I've also notified the CCS Team in case they have more feedback to provide.

Regards,
Ryan

0 Sarbjeet Singh over 2 years ago in reply to Ryan Brown1

Prodigy 50 points

Thank you for the efforts... will try as suggested..

Zigbee & Thread

Zigbee & Thread forum

CC2652R7: Loading Programm to custom board (without xds110)