CC2652P: Configuring CCS for custom board based on E72-2G4M20S1E (CC2652P1FRGZ)

haim alon

Prodigy 30 points

Part Number: CC2652P
Other Parts Discussed in Thread: CC1352P, SYSCONFIG

Tool/software:

Hello

Any idea how to configure CCS to develop the software to my custom board?

I'm using LP-XDS100 and I want to start from the Zigbee End Device Switch Example App

My main consideration is the package/pinout

Thanks

Haim

25 days ago

0 Ryan Brown1 25 days ago

TI__Guru**** 217507 points

Hello Haim,

The CC2652P is binary compatible with the CC1352P which means you can start development from a LAUNCHXL-CC1352P-2 ZED switch example. For custom hardware considerations you can then select "USE CUSTOM BOARD" in the SysConfig Board View to access the device pinmux beyond what the LaunchPad allocates.

Regards,
Ryan

0 haim alon 25 days ago in reply to Ryan Brown1

Prodigy 30 points

Thanks Ryan

I've started from this example. I had to choose between CC1352P1F3 and CC2652P1F - which one is suitable for the e72?

Also - I'm using SysCfg to add the buttons of my board. For example - one button is connected to DIO8 which is pin 3 of the e72. But when I want to allocate the pin it looks like DIO8 is pin 14 and it is allocated to the "LaunchPad SPI bus"

Is it OK to suppress this warning? And what about the different pin number?

Thanks

Haim

+1 Ryan Brown1 25 days ago in reply to haim alon

TI__Guru**** 217507 points

CC2652P1F, and I provided previous instructions for using custom boards with Sysconfig. Contact the manufacturers of the e72 module if you need specific support with their hardware.

Regards,
Ryan

Zigbee & Thread

Zigbee & Thread forum

CC2652P: Configuring CCS for custom board based on E72-2G4M20S1E (CC2652P1FRGZ)