ALL Led Blinking After send command from ZAP to ZNP

Hung Nguyen5

Other Parts Discussed in Thread: Z-STACK

Hi everyone.

I'm not familiar with Z-Stack ZAP.

after i send a command from ZAP to ZNP, all LED in the board blinking. After that, all features in the board do not responding end i can't send anything?

Thanks you.

over 12 years ago

0 TheDarkSide over 12 years ago

TI__Genius 16570 points

Hi,

can you please be more specific? What type of commands are you sending, what type of board configuration are using (is it 2531 dongle or SmartRF05) and which LEDs are blinking?

Thanks,

TheDarkSide

0 Hung Nguyen5 over 12 years ago in reply to TheDarkSide

Prodigy 80 points

Hi TheDarkSide

thank you for your reply.

I'am using my own board, but all led in my board is referenced from the reference in ti.com web.

I send some zdo commands, specific ZDO_DEVICE_ANNCE. After i send this command, coordinator has received the broadcast message, but all Leds in the end device continually blink.

0 YiKai Chen over 12 years ago in reply to Hung Nguyen5

Guru 735695 points

Hi Hung,Could you specify the Z-Stack version you use? By the way, is it always the same result if you reboot your device and try again?

0 Hung Nguyen5 over 12 years ago in reply to YiKai Chen

Prodigy 80 points

Hi YiKai Chen.

I'm using Z-Stack v 2.5.1.

Yes. The same result occur after i reboot my device.

Thank you

Zigbee & Thread

Zigbee & Thread forum

ALL Led Blinking After send command from ZAP to ZNP