Z Tool send command using ZNP

sivasankar sekar

Intellectual 745 points

Other Parts Discussed in Thread: CC2531EMK

Hi Friends,

In my PC i connected the Packet Sniffer as ZNP and i try to send the sys_reset command from Z Tool 2.0.

If i send the command how can i check, if the command is send or not from my ZNP?

over 11 years ago

0 YiKai Chen over 11 years ago

Guru 735685 points

If you send ZNP command correctly, you should receive ZNP command ack. You can refer to http://e2e.ti.com/cfs-file.ashx/__key/CommunityServer-Discussions-Components-Files/158/8865.CC2530ZNP-Interface-Specification.pdf

0 TopCat over 11 years ago

TI__Genius 9180 points

sivasankar sekar said:

i connected the Packet Sniffer as ZNP

Please confirm that you are reprogramming the CC2531EMK (USB Dongle) with the ZNP firmware. This will not work if it is still programmed as a packet sniffer.

Regards, TC.

0 YiKai Chen over 11 years ago

Guru 735685 points

Hi sivasarkar,

I find you shot similar question in different post. I suggest you post them in one thread. People in this forum will still try to help.

Zigbee & Thread

Zigbee & Thread forum

Z Tool send command using ZNP