CC2530 GPIO HAL drivers

Desmond Correia

Other Parts Discussed in Thread: Z-STACK

Hello,

I was wondering where I can find GPIO HAL drivers. I understand how to use the GPIO ports just fine but I will need to write a library to do it since I don't want to constantly do it. So I was hoping someone already wrote a small library to do it.

over 11 years ago

0 YiKai Chen over 11 years ago

Guru 735695 points

If you use Z-Stack, you can refer to hal_key.c

0 S over 11 years ago

TI__Mastermind 35795 points

Desmond,

You may also refer to GPIO macros defined in hal_board_cfg.h ( for Z-Stack). These are only used to control specific GPIOs using MT command, but if you wish you may modify these macros and use for generic GPIO setting.

Thanks,

Saurabh

Zigbee & Thread

Zigbee & Thread forum

CC2530 GPIO HAL drivers